• Parallel jaw faces with extra-large contact surfaces
• Clamping of various shapes, along the whole length of the rail
• Universally applicable
• Light and easy-to-handle
• No need for tools for switching between clamping and spreading

Features:

• Parallel jaw faces: The large, flat jaw faces made from impact- and fracture-resistant reinforced polyamide are almost parallel. For gentle clamping of a very wide range of ­different shapes over the entire length of the rail, without spacers.
• High-quality profiled rail: The BESSEY hollow profile rail from our own drawing plant has been especially optimised for clamps. The profile acts as a reliable reinforcement against torsional forces, while the serration prevents the clamp from slipping.
• Removable end stop: The end stop made from impact-resistant polyamide also gives the clamp added support. It can be removed without any tools, to allow the lower arm to be quickly turned around and used for spreading.

Areas of application

• Furniture and joinery works
• Interior fittings
• DIY
• Large-area clamping and spreading

Safety information

• Use the product only in its original condition.
• Use the product only for its intended purpose. Improper use can cause personal injury or property damage.
• Wear safety glasses to protect your eyes.
• Wear work or assembly gloves to protect your hands.
• Wear safety footwear to protect your feet.
• Thew handle must always be free of oil and grease to prevent slipping.
• Keep the product out of reach of children.
• Small parts must not be swallowed or inserted into body openings.
• Check the product for damage before each use and make sure that all moving parts are working properly.
• A damaged product must not be used.
• Follow the care instructions for each product – see www.bessey.de.
• Use only original BESSEY spare parts
• The clamping tool must not be used for lifting, pulling or leaning.
• The clamping tool must not be used to secure cargo during transportation.
• The clamping tool may only be tightened by hand without any additional aids.
• The clamping tool must not be used for permanent installation.
• Regularly check that the end stop is working properly when using clamps.

Material/Surface

• Upper and lower section made of reinforced PA6 plastic with inserted sheet metal parts for reinforcement
• Hollow profile rail made of steel, cold-drawn, galvanised
• Spindle with trapezoidal thread in rolled steel, burnished
• Handle made of wood, water-based paint
• Pressure plate made of steel, cold pressed, galvanised

Care instructions

• Regular maintenance is necessary – only then can a secure hold be guaranteed (no slipping of the sliding bracket).
• Clean the rails with solvent.
• Always keep the rail free of grease, oil or dried glue, waxes and silicone-based release agents.
• Clean the fluting on the rails with a steel brush.
• Clean and oil the spindle regularly.

Please Note that Product may differ eg. colour, size from the product Image displayed on website. Kindly check the specifications provided to make better purchase decision. M.R.P Prices and specifications are subject to change without notice.